遠傳帶毛細管隔膜壓力變送器Fartron with capillary diaphragm pressure trans
技術性能
使用對象： 粘稠液體、直接測量的高溫氣體或蒸汽，化工腐蝕性介質，易于結晶的液體。
測量范圍： 見選型規格表
輸出信號： 4～20mA dc.輸出，疊加HART協議數字信號（兩線制）
電 源： 外部供電24V dc.，電源范圍12V～45V
危險場所安裝： 隔爆型dIICT6;
本安型 iaIICT6;
技術指標
(在無遷移、316不銹鋼隔離膜片及其他標準測試條件下。)
精 度：±0.1%，±0.075%
應用及選型：
被測介質用引壓管引出時，易固化或結晶；
被測介質中含有固體懸浮物或過于粘稠，容易堵塞引壓管；
被測介質溫度過高或有腐蝕性等，不利于直接測量；
被測介質是食品或其他需要保持衛生條件，不能污染的介質；
Technical Performance
Application Object: Thick liquids, directly measured high-temperature gases or vapors, chemical corrosive media, liquids prone to crystallization.
Measurement Range: Refer to the selection specification table
Output Signal: 4-20mA dc. output, with HART protocol digital signal (two-wire system)
Power Supply: External power supply 24V dc., power supply range 12V - 45V
Installation in Hazardous Areas: Flameproof type dIICT6; Explosion-proof type iaIICT6; Technical indicators
(under non-migration, 316 stainless steel diaphragm and other standard test conditions.)
Accuracy: ±0.1%, ±0.075%
Application and selection:
When the measured medium is led out through a pressure guiding tube, it is prone to solidification or crystallization;
If the measured medium contains solid suspended matter or is too viscous, it is likely to clog the pressure guiding tube;
If the temperature of the measured medium is too high or it is corrosive, direct measurement is not feasible;
The measured medium is food or other media that require maintaining hygiene conditions and cannot be contaminated;
